TargetTalk

So I had my Anschutz 2002CA out of the metal stock, seeing with what modifications I can fit my 1807 action into it. I assembled the 2002CA back into its stock, and noticed the o ring in the picture on the table. It must have come out of the 2002CA. Anyone know what it is?

I didn't dissemble the 2002CA anymore than just remove from stock. In the picture is the front action screw for sxale. The diameter is ~7.8mm and the inside diameter is ~4.6mm.

Thanks!

I had a 2002; I had a couple of rubber rings like that, but they were used for the washers for my palmblock, they went on the end of the screws to keep the spacers from coming out as easily. I believe my action screws had small black, thin metal washers that went with them.

-Zach

Thanks Zach. You are correct, I figured it out at work yesterday aftet looking at the parts diagram. I knew I seen it before.