Page 1 of 1

cylinder adapter for Anschutz/Feinwerkebau/Walther etc

Posted: Tue Jun 20, 2017 6:18 pm
by Ltdave
these babies have quite small orifices in them which i ASSUME acts as a restriction valve to protect the air cylinders...

ive got a chance to get a valve that's restricted to slow-fill. according to the specifications it should fill in about 10 seconds...

will adding this restrictor valve to the adapter be much of a hindrance to filling the cylinder? im an electrician and really dont know a LOT about pneumatics...


thanks

Re: cylinder adapter for Anschutz/Feinwerkebau/Walther etc

Posted: Wed Jun 21, 2017 2:50 am
by TenMetrePeter
Guns with removable cylinders, which is most precision guns like those you mention, should fill OK with a slow fill restriction and 10 seconds sounds about right.

I dont see any reason to choose or add such a restrictor to a normal DIN setup except maybe for unsupervised Junior use. However 300bar cylinders usually have valves with smaller restriction.

Some sporter/hunter PCP guns with fixed cylinder like AirArms S400 may not take air well when completely empty as a quick burst of air can help close the firing pot valve.