Page 1 of 1

Hammerli AP20 low velocity?

Posted: Thu Jul 20, 2017 4:43 pm
by little miss horrible
We recently acquired an AP20 as a club pistol, and we've noticed that the muzzle velocity seems to be a bit on the low side ... in that it's very quiet and the pellets aren't so much punching through the target as tearing through it, which is giving the scorer a nervous breakdown. Not had the chance to chronograph it yet, but there's clearly something slightly odd going on.

We've had it from new, and it's always done this. It's doing it consistently, in that we're getting some decent grouping and scores out of the thing. It doesn't appear to be leaking air anywhere: we can't hear anything escaping, and it's holding cylinder pressure between sessions. The only time we've done anything to the mechanism since we've had it was to flip the reducer round to have the cylinder pointing in a more conventional direction. It doesn't appear to have any means of velocity adjustment, and there's nothing in the manual the suggest that it should have.

Any ideas, o lovely people of the internet? ::o)

Re: Hammerli AP20 low velocity?

Posted: Thu Jul 20, 2017 5:15 pm
by william
Always impolite to answer a question with a question, but answering with 3 questions - that's another story.

1. Where did you get it?
2. Did you ask that person's advice?
3. If you're in the US, did you contact Larry Carter? He's been dealing in Hammerli since Moses crossed the Delaware (or was it Washington crossing the Red Sea - I get confused).

Re: Hammerli AP20 low velocity?

Posted: Thu Jul 20, 2017 5:35 pm
by little miss horrible
We got it from the same local shooting shop that supplies various bits of rimfire kit, various airguns, and fills our dive bottle for us. We're in the UK.

Re: Hammerli AP20 low velocity?

Posted: Thu Jul 20, 2017 8:13 pm
by Rover
Tighten or replace the striker spring.

Re: Hammerli AP20 low velocity?

Posted: Fri Jul 21, 2017 3:07 am
by TenMetrePeter
and ensure there is no oil particularly silicone anywhere near the striker (parts 47 and 78 in the diagram)
http://www.bisley-uk.com/products.php?c=556
I cant see any adjuster.
Striker hammers must be dry moly lubed never oiled. too easy to give the whole a "maintenance spray " and get it inside.

Re: Hammerli AP20 low velocity?

Posted: Fri Jul 21, 2017 6:06 am
by m1963
Perhaps send a private message to Uhlrich Eichstädt, the manufacturers European representative.

http://www.targettalk.org/memberlist.ph ... file&u=314

It is almost time for holiday, so a response may be slow in coming.

Regards,
m1963

Re: Hammerli AP20 low velocity?

Posted: Fri Jul 21, 2017 6:56 am
by David Levene
Have you tried EMRR?

They are a (the?) UK distributor for Walther/Hammerli airguns.