Schematics for the Hammerli Model 100
Page 1 of 1

Author:  JoeS [ Sat Apr 22, 2017 7:35 pm ]
Post subject:  Schematics for the Hammerli Model 100

Does anyone know where a person could buy/find schematics for the Hammerlis 100? I'm fairly adept at things mechanical but the trigger assembly is a little daunting :-) Thank you, Joe.

Author:  SamEEE [ Sun Apr 23, 2017 3:31 am ]
Post subject:  Re: Schematics for the Hammerli Model 100

Here I made some detailed technical drawings.

Author:  Gwhite [ Sun Apr 23, 2017 10:08 am ]
Post subject:  Re: Schematics for the Hammerli Model 100

I would guess that it is at least evolved from, and is vaguely similar to, the 103 design. I think you can find a lot more info on the 103 trigger. I know they added a screw adjustment in the 103 trigger, but it may be that the rest of the design is close enough to figure it out. It sounds like the screw was added to adjust compression on a fixed spring that had to be swapped out or tweaked in the 100 trigger.

Good luck!

Author:  JoeS [ Mon Apr 24, 2017 10:13 pm ]
Post subject:  Re: Schematics for the Hammerli Model 100

Sameee, Thank you much for your reply. I can tell you realize that I'm a simpleton, probably from the obvious lack of knowledge I have of the subject. Thank you again for helping, your dumbing down your answer has helped to enlighten me although I must admit the "Here be dragons" technology is way over my head. I will try to google it and get my knowledge up to par before I ask another stupid question :-)

Gwhite, Thank you for your help. I contacted a place called Larry's Guns and a nice lady there named DeAnna sent me a schematic for the 103. From what I can tell the two are very similar although the broken spring I'm trying to contend with is somewhat different or at least appears to be than the one in the drawing. I'll search the internet as well as this site for 103 information Thank you again for your help, Joe :-)

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group