Page 1 of 1

FWB 300

Posted: Thu Apr 20, 2017 5:45 pm
by JOKER708
Replacing seals and spring --
Front seal was bad due to my fault --
Ordered kit with single wrap spring to see about improvement --
It had a single wrap spring in it to my surprise ---EXCEPT --
The one in it was 8 1/8 --- spring in kit --9 1/2 " --
What is factory length please -- can someone in the know measure one they
Have and let me know which one of these to use ---
That long one is gonna really up the cocking pressure and speed ---
Thank You --

Re: FWB 300

Posted: Wed Apr 26, 2017 7:45 am
by Rover
Since no one appears to be helping you out....

I suspect the spring in your gun has been compressed over the years, thereby shortening it compared to a new spring. Install the new (longer) spring and give the gun a try. I wouldn't be at all concerned with the cocking effort being increased; velocity, perhaps. You may like the results.

Re: FWB 300

Posted: Sat Apr 29, 2017 11:33 am
by Packrat1947
I once put a Macarri spring in my 300. I took measurements of the old spring and the new. After a few months I removed the Macarri and returned to the original. The Macarri had shrunk over an inch - although shot very little.

The Macarri was supposed to be extra strong, but I didn't like the way the rifle behaved. It was no longer a pleasant smooth shooter. It was kind of "raspy" or "harsh". Hard to put into words. Even plinking in the backyard, or shooting grackles and starlings was not pleasant.

If you want an original-type counter-wound double-spring you can get it from Nikkonos on ebay. He has supplied me with several new plastic stock parts that had deteriorated on my 1985 FWB 300S Universal. He is in Canada.

http://stores.ebay.com/Olympic-Marksman-Equipment

Good Shooting and luck,
Packrat1947

Re: FWB 300

Posted: Sat Apr 29, 2017 5:41 pm
by Wynne G Oldman
Mr. Rover is correct. I have rebuilt a FWB 300S with a genuine repair kit from FWB with 2 springs. The old springs that came out of the rifle were considerably shorter than the replacements. The rifle shot like new afterwards, and should continue to do so for many years to come.

Re: FWB 300

Posted: Sun Apr 30, 2017 3:39 am
by kevinweiho
Wynne G Oldman wrote:Mr. Rover is correct. I have rebuilt a FWB 300S with a genuine repair kit from FWB with 2 springs. The old springs that came out of the rifle were considerably shorter than the replacements. The rifle shot like new afterwards, and should continue to do so for many years to come.
I've heard from a source that OEM FWB springs should last around 100k shots. My FWB 80 has over 35k shots, using the older springs and replacing the deteriorated seals, it's still capable of single hole groups.

Re: FWB 300

Posted: Sat May 06, 2017 11:31 pm
by 6mmintl
You might want to scagged the spring, get a threaded rod with nuts and 2 washers each end.

Measure the I'd, measure the wire dia. And number of coils and figure out total length depressed coil against coil and make a spacer that length and inside diameter of coils.

Compress spring and straighten any twisting of coils and let it set 4 hrs.

Your spring will take a set and last longer, giving you max power for its size, coils, mechanical strength and it prevents premature faulure.

Make sure you reground ends square to length and deburr, Polish ends.