TargetTalk

A forum to talk about Olympic style shooting, rifle or pistol, 10 meters to 50 meters, and whatever is in between. Hosted by Pilkguns.com
It is currently Fri May 26, 2017 6:08 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 6 posts ] 
Author Message
PostPosted: Mon Apr 10, 2017 10:32 pm 
Offline

Joined: Wed Feb 07, 2007 11:29 am
Posts: 93
I have seen on one stock a factory cheekpiece adjuster that had a side adjustment. Has anyone else seen this and are parts currently available?

Thanks
Mark Trew


Top
 Profile  
 
PostPosted: Tue Apr 11, 2017 1:34 am 
Offline

Joined: Mon Jan 03, 2011 11:33 am
Posts: 1207
Location: Taunton, Somerset
Could you be a little more specific? Did you mean a cheek piece that was adjustable side to side, or that the cheek piece was adjusted from the side.

I wonder of you mean the Precise cheek piece used on the 19/2018 alu stocks and the 1914.


Top
 Profile  
 
PostPosted: Tue Apr 11, 2017 3:05 pm 
Offline

Joined: Fri Jan 18, 2013 11:59 pm
Posts: 253
The cheekpiece on the new Precise aluminum stock adjust as you say.

Mark


Top
 Profile  
 
PostPosted: Tue Apr 11, 2017 3:15 pm 
Offline

Joined: Wed Feb 07, 2007 11:29 am
Posts: 93
Yes, I agree my question left a lot of room for speculation.

Stock is an 1813, later vintage version. Under the normal 1813 attachment, the cheek piece has an additional piece of metal with recessed nuts to allow for lateral movement.

I saw this on a friends stock and would like to get the additional parts for a couple of my stocks. They do look like original Anschutz. And no it is not a Precise, much too old.

Send an email to Mrktrew@verizon.net and I will send pictures.

Thanks
Mark Trew


Top
 Profile  
 
PostPosted: Tue Apr 11, 2017 3:23 pm 
Offline

Joined: Mon Jan 03, 2011 11:33 am
Posts: 1207
Location: Taunton, Somerset
That's not a factory piece. I think the owner (or a previous owner) has added the sideways adjustment. The same spring loaded up-down hardware was used from about 1972 until the 1913 was upgraded with the 4-axis 2013 hardware in the '90s. The bracket had round countersunk holes for simple wood screws.

You'd need to have a similar intermediate plate made, or turn the holes in the bracket into slits with a file.


Top
 Profile  
 
PostPosted: Sat Apr 15, 2017 11:14 am 
Offline

Joined: Mon Feb 27, 2012 2:12 pm
Posts: 32
Location: AZ
Look at older 2013 schematic.

#69 on drawing.........part number 4812-15. That is the plate you are asking about. You would have to inlay it into your style cheek piece.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group