Pardini counterweight recoil reduction system

Brought to you by Zero Bullet Company Inc.

Moderators: pilkguns, m1963, Isabel1130

Post Reply
User avatar
crankythunder
Posts: 251
Joined: Tue Dec 22, 2009 6:57 pm
Location: The ugly side of Hell, Michigan
Contact:

Pardini counterweight recoil reduction system

Post by crankythunder »

Hi guys!

Thinking about reducing the weight of my pardini sp bullseye, and rather then removing the recoil weights completely since I like the way that they reduce the recoil, I am thinking about replacing the steel weights with aluminum weights.

They measure 0.310 inch in diameter and I have some 0.312 aluminum stock that I could manufacture weights.

Cannot fathom any damage this would cause other then spring fatigue.

What do you guys think?

Regards,
Crankster
ChipEck
Posts: 462
Joined: Tue Apr 23, 2013 5:50 pm
Location: Wisconsin

Re: Pardini counterweight recoil reduction system

Post by ChipEck »

Would it be easier to remove two or four of the weights and springs? I doubt aluminum would have enough mass to noticeably affect recoil.


JUst a FYI. I played with mine forever putting the springs in front, mixing some in from and some in back. The factory way was what I ended up with.

Chip
ghillieman
Posts: 251
Joined: Wed Jan 05, 2005 11:07 am
Location: Mineola, TX

Re: Pardini counterweight recoil reduction system

Post by ghillieman »

With less mass of aluminum you will loose a little bit of the dampening effect. But let's be realistic, the recoil of a 22 is not going to keep you from cleaning the target, but an improperly balanced pistol might.
mr alexander
Posts: 200
Joined: Sun Oct 16, 2011 2:47 pm

Re: Pardini counterweight recoil reduction system

Post by mr alexander »

Crankster,

Instead of making aluminum weights, could blind holes be drilled into the steel weights already on hand?

If this doesn't work out to your satisfaction, does Pardini have new sets of the original weights available

for purchase?
bking
Posts: 54
Joined: Wed Mar 21, 2012 12:01 pm
Location: pdx

Re: Pardini counterweight recoil reduction system

Post by bking »

As I understand it the whole point is that you can run 0, 2, 4, or 6 weights. Just pull some out.
Post Reply