.32 bullet mold

Brought to you by Zero Bullet Company Inc.

Moderators: pilkguns, m1963, Isabel1130

Post Reply
glr1
Posts: 142
Joined: Mon Dec 28, 2009 5:57 am

.32 bullet mold

Post by glr1 »

Looking for recommendations on 32bullet mold for 32sw-for gsp , thank you
fc60
Posts: 732
Joined: Fri Nov 25, 2005 11:46 am
Location: Western Washington State, USA 98385

Re: .32 bullet mold

Post by fc60 »

Greetings,

Consider a Saeco #323 in four cavity.

The RCBS 32-098-WC shoots well; but, is only available in 2-cavity.

If you have a stock Walther GSP-C, or GSP-C Expert, odds are the barrel measure 0.3135" +.

Size the as cast bullet to 0.314".

Use a soft lube, like NRA 50-50, Alox-Beeswax.

Cast with a soft Lead alloy, about 8-10 BHN

Lapua brass and 1.65 grains of Winchester WST have worked well for me in the past.

Happy casting, there are not many of us left.

Cheers,

Dave
ghillieman
Posts: 251
Joined: Wed Jan 05, 2005 11:07 am
Location: Mineola, TX

Re: .32 bullet mold

Post by ghillieman »

I'm getting good results with the Magma Engineering 93gr button nose flat base wadcutter.
oldcaster
Posts: 617
Joined: Tue Dec 01, 2009 9:09 pm
Location: Chesterfield Missouri

Re: .32 bullet mold

Post by oldcaster »

I like exactly what Dave (FC60) recommended. I like alox 50/50 but some seem to come out of the grooves too easily, specifically Lars Alox 50/50. I use the Lars 2500 instead and it seems to work well. Before this I exclusively used 50/50 in other brands and was happy.
Post Reply